Faux Bleach

By
Hot Rod Scrampers
Advanced Scramping Team Designer

Supplies

•  Daisy Delight Stamp Set (TAC - retired)
•  Greeting (TAC)
•  Kaleidacolor Bouquet Ink Pad (Tsukineko)
•  Versamark stamp pad (Tsukineko)
•  Noir Black Palette Hybrid Ink Pad (Stewart Superior)
•  Vanilla Cardstock (unknown)
        Cut 8-1/2” x 5-1/2”
        Cut 4” x 5-1/4”
        Scraps
•  Orange Cardstock (Unknown)
        Cut 5-1/2 x 4-1/4”
        Scraps
•  Light Green Cardstock scraps
•  White Cardstock scrap
•  Clear Ultra Detail embossing powder (Mark Enterprises-Stampendous)
•  Fun Fur Fiber (Lion Brand)
•  Black Brads (Making Memories)
•  Scissors (Fiskars)
•  Small Handheld Hole Punch (Fiskars)
•  Southwest Corner Punch (Marvy)
•  Hydra Sponge (TAC)
•  Yellow Button
•  Hermafix tabs (Herma)
•  Household Iron
•  Embossing Heat Tool (Marvy Uchida)
•  Paper Crimper (Fiskars)
•  Paper cutter (Fiskars 12”)
•  Scrappy Glue (Magic Scraps) 

Instructions:

1       Stamp image on 4” x 5-1/4” vanilla cardstock with Versamark ink.  Sprinkle with clear embossing powder and heat with embossing tool. 

2       Brayer diagonally with Bouquet Kaleidacolor inkpad.  Repeat these two steps on a scrap piece of Vanilla cardstock for the greeting. 

3.    Lay stamped and brayered cardstock (both card layer and the scrap piece) face up and cover with a clean piece of cardstock. Iron until embossing powder is melted. The “resist” image will show through, hence the “Faux Bleach” name. 

4.    Stamp greeting with Noir Black inkpad on scrap piece. Sponge edges of both greeting and card layer with Noir Black ink. 

5.    Mat both card layer and greeting with orange cardstock leaving about an 1/8” border. 

6.    Cut a strip of light green cardstock about 1” x 4” and run through crimper. Sponge edges with Noir Black ink. Glue vertically to center of card and trim edges as needed. 

7.    Glue greeting over crimped strip and attach black brads as desired. 

8.    Punch corners with corner punch and run fiber around the edges. 

9.    Stamp flower image on scrap vanilla cardstock with Bouquet Kaleidacolor inkpad and cut out. Attach to lower right corner of greeting. Run fiber through yellow button and knot and glue to center of flower. 

10.    Fold 8-1/2” x 5-1/2” vanilla cardstock in half to make card. Glue entire matted card front to folded vanilla cardstock.

If you would like to print this technique click here.  Once you've saved or printed the technique sheet, use your browser's back button to return.

Note: You will need Adobe Acrobat Reader to obtain this file.  If you do not have Adobe Acrobat, click here to download and install.